- Increases productivity and efficiency
- Simple installation takes less than an hour
- Includes all necessary tools (except electric drill)
- Includes column bundled for resistive heating
(Contact us to discuss your application)
This conversion kit has everything you need, including the tools, to convert your HP6890 or Agilent 7890 to a fast GC. Most of the work involves the installation of an adapter plate, which relocates the detector next to the injector to make room for the high speed components.
The included VICI column heating unit provides precise temperature programming with rapid heating and cooling of a low mass nickel-clad or nickel-wire column, also included. The column is resistively-heated by applying a low-voltage current to the column coating or wire. Column temperature is controlled by regulating the amount of current, with a small fan providing speedy cooling of the low-mass column to near-ambient temperature.
Included in the kit:
| 1 | T15 screwdriver |
| 1 | T20 screwdriver |
| 4 | 6/32" x 3/4" screws |
| 4 | M4 screws |
| 1 | knife |
| 1 | FID guide block |
| 1 | 3/8" brad drill bit |
| 1 | cutting pliers |
| 1 | hole saw |
| 1 | metal wrench |
| 1 | ruler |
| 1 | injector adapter fitting assembly |
| 1 | detector adapter fitting assembly |
| 1 | detector insulation cup |
| 1 | fan bracket |
| 1 | cooling fan |
| 1 | fan extension harness |
| 1 | ground harness |
| 1 | FID igniter harness |
| 1 | FID electrometer harness |
| 1 | FID heater harness |
| 1 | column harness |
| 1 | power supply harness |
| 1 | power supply AC cord |
| 1 | USB cord |
| 1 | adapter plate |
| 1 | column controller |
| 1 | power supply |
| 1 | instructions |
